XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
First Pages Page 4
CARE AND FEEDING OF CARBON FIBER
Throughout your Kit we have deliberately cut the bolt holes in the CF parts on the
small side for a good tight fit. Thread them up through and then give an extra
twist or two so they will be snug but free.
Carbon fiber is a laminate, much like plywood, and is produced similar to laying
up fiberglass. While the material is extremely strong and light, without proper
attention it can begin to delaminate, leaving a “frayed” appearance around the
edges. All carbon fiber parts used in your SCX – 60CF have been CNC machine
cut from flat sheets, so the edges are unfinished.
In a well ventilated area we suggest you run some fine-grit emery cloth or sand
paper around the edge of all your new carbon fiber pieces. Wear a dust mask
while you sand. Then, blow off the dust and run a small bead of C.A. glue, the
same stuff you use to glue tires, around the edge. Spread the glue out with a
hobby knife so it covers the entire edge of the part, but don’t let any drip on the
shiny front or back of the part. A little dab’ll do ya. This will seal the edges.
Every few weekends take a look at the carbon fiber parts and, if any fraying
appears, sand and glue to keep it to a minimum. Your CF parts will last many
years.
Some drivers who race on abrasive surfaces use a protective film under their
chassis to keep that carbon fiber looking great.
.