XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag F
Finish It Up
Page 38
F14) If your servo is wide, it may foul the corners of
the nose piece. Not to worry, just use a file or a
rotary tool to remove about 1/8” of material from
raised corner of the nose piece where indicated.
We have been doing this for several years and
there is lots of material here, so you won’t
weaken it. Only the left side has been done in
this photo so you can see the difference.
F15) Install the antenna tube into its mount by pushing it
through from the top. Extend a part of the tube
down below the mount so the wire does not touch
the CF. This helps keep the glitch demon in his
cage.
F16) The photo on the left is Paul’s car with E.S.C. and receiver installed. The
right photo is Team driver Dan Reino’s car with the shorty pack forward
and the E.S.C. between the battery and motor. Dan’s way is not legal for
R.O.A.R. but it works well at Thunder R/C, Dan’s home track. Of course,
you can do this any way you want!
F17) Install the
motor,
using the
saved
screws.