XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag F
Finish It Up
Page 37
F11) We are showing you the top deck here because it makes sense to us this
way, but you may want to install the electronics before the top deck.
Place the smallest two chassis shims on the front top deck supports (left
photo) and place the top deck over its supports. Use seven 4-40 X 3/8”
cap head screws for the front deck supports and center posts.
F12 Place a 4-40 X 3/8” Button Head screw through each dialed carbon fiber (!)
Body Mount (XF 6321), then attach the rear of the top deck. The body
mounts should be at 90
o
to the top deck, not the top deck support. Team
drivers often put a small bevel around the top and bottom of the rounded
portion of these body mounts so the body clips slide on and off easier.
ELECTRONICS
F13) Mount the servo in the Cubed just as it
was in the B4.2. Attach the servo link.
If you have not removed the servo
horn, if should be set perfectly. Don’t
be confused. This is a photo of Paul’s
car and he mounts his transponder and
E.S.C. capacitor on top of the servo