XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag F
Finish It Up
Page 35
F5) Place four 4-40
X 3/8” flat head
screws up
through the
chassis, one at
each corner of
the battery
compartment,
and put a 0.060”
shim on each
bolt.
F6) Install the four 7/8” Stand-Offs (XF
6802). If you are into thread lock, a
drop in each one.
F7) Find the two button head screws you saved from inst. 11 and the two 4-40
X 1/4 button head screws (XF 6041) from Bag F. Install the four 0.156”
Hex Stand-Offs (XF 6805) in the slots of the battery strap (XF 1229).
Finger tight for now. The stand-offs will hang down to locate the battery.
F8) Check the Set-Up Sheet and Tuning Section,
then put the battery in the car where you want it.
Now put the battery strap in position, hold the
strap in with four 4-40 X 3/8” button head screws
(XF 6042) finger tight, and adjust the stand-offs
to keep the battery in the desired position. Now
tighten the stand-offs. You can leave the battery
in for now or remove it, then tighten the battery strap to the 7/8” stand-
offs. The side of the battery strap with the dog leg is the front.