XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag F
Finish It Up
Page 34
BAG F
FINISH IT UP
F1) Place two 3/8” flat head screws up through the two
holes at the right rear corner of the chassis.
F2) Remove the bag of
Chassis Shims (XF 1012)
from Bag F and place
one of the medium-size
shims over the two bolts
from F1 above. Then
bolt on a Rear Top Deck
Support (XF 1311). If
you use thread lock, a
drop in each hole of the top deck support. Repeat for the left side.
F3) Place three 4-40 X 3/8” flat heads up from under the chassis in the center
just ahead of the battery compartment and put the long chassis shim over
them.
F4) Install the three long 1” Stand-Offs (XF
6801). A drop of thread lock on the stand-
offs if you use it. Again, a cloth and some
pliers will help.