XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag E
Rear Suspension
Page 33
E14) Place the shims under the toe-in bar and secure with two 4-40 X 1/2” flat
head screws saved from inst # 11. The photos show one of each shim, or
0.090”.
E15) Using the hardware you saved from the rear shocks, install the upper
shock mounting bolt in the tower. Check the Set-Up Sheet and Tuning
Section to determine how your shocks will be mounted. Here we are
using the #2 hole. If you have Big Bore shocks, install a 0.060” spacer
(XF 5702).
E16) Install the top of the shocks just as they
were on the B 4.2.
E17) Put the dogbone in the outdrive (short arrow) and snap the ball cup over
the ball stud (long arrow), then bolt on the bottom of the shock.