XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag E
Rear Suspension
Page 32
E9) Install the hinge pins (XF 6141) in the
bushings.
E10) Check the Set-Up Sheet and Tuning
Section to determine how you will space
your control arms on the hinge pin. Slide at
least one thin shim over the hinge pin to
prevent friction between the control arm
and hinge pin brace. Here we have used
two dialed Real Men Wear Black 0.030”
shims.
E11) Place the two control arms on the hinge
pins. Shock holes to the rear!
E12) Two Toe-In Bars (XF 3211) are in Bag E,
marked 3 and 4. Check the Set-Up Sheet
and Tuning Section to determine which
bar you will use. Here we have used the
4
o
bar. Slide the bar onto the hinge pins.
Notice the bar will move up and down.
E13) Check the Set-Up Sheet and Tuning Section to
determine how much anti-squat you will use, and select
your Anti-Squat Shims (XF 3250) from the little bag. The
two smaller shims are 0.030” thick, and four larger ones
0.060” thick, which allow you to make any combination
from zero to 0.150”. Each 0.030” = about 1 degree.