XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag D
Transmission Installation
Page 28
D8) Place a transmission shim over each of
the 1” bolts that come up through the
bulkhead. For this photo we have used
0.060” shims so they show well. This is
strictly for purposes of clarity. It is
important that all four shims be the same
size on your X – 6 Cubed!
D9) Place the other two T\transmission shims
over the front bosses of the transmission
cradle. In this photo we have used the
0.030” shims for clarity. Again, make sure
ALL SHIMS ARE THE SAME SIZE!
D10) Slide the transmission into its
cradle over the shims. The
back two shims will stay just
fine, but the front two are
another matter. Some drivers
take the right front one out
until after the left front bolt is
installed, then slide the right
front shim back in. Also
quickly check that the motor
plate mates properly with the
support bracket. See the
photo in D14.
D11) Put a washer
over a 4-40
X 38” bolt,
and install
the left front
of the
transmission.
Finger tight
for now.