XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag D
Transmission Installation
Page 27
D4) Place two 3/8” flat head screws up from under the chassis for the Motor
plate support bracket. Put one 0.030” spacer (XF 3250) on each screw,
and install the motor plate support bracket (XF 1130). Leave these
screws finger tight for now. Note that the bracket is off-set to the left.
D5) Place the bulkhead and shock tower
assembly into the rear of the
transmission cradle and secure with
the 1/2” cap head you saved from
inst # 16 (long arrow). The bulkhead
fits over the 1” flat head screws
(short arrow).
D6) Here is a photo from the rear:
D7) Gather together the two
4-40 X 3/8” cap head
screws saved from Inst.
#14 and remove from
Bag D two #4 mini nuts
(XF 6073), and four #4
flat washers. Also, check the Set-Up Sheet and Tuning Section to
determine which Transmission Shims (XF 5702) you will use, and remove
those four shims from the little bag. Here we are using 0.030” (arrows).