XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag D
Transmission Installation
Page 26
BAG D
TRANSMISSION INSTALLATION
D1) Place two 3/8” flat head screws (XF 6022) up from under the chassis, put
the 2mm Hinge Pin Brace Spacer (XF 3262) over the screws, and install
the Hinge Pin Brace (XF 3260) with the bushing holes (arrows) facing
back.
D2) Place two 3/8” flat head screws (short
arrows) up from under the chassis for
the front of the transmission cradle and
two 1” flat head screws (XF 6027, long
arrows) for the back of the cradle
D3) Install the transmission cradle
(XF5030). The front two 3/8 screws will
thread in to the cradle and tighten down.
If you use thread lock, a drop in each
front hole now. The two 1” screws just
go through the cradle, and you may
have to hold them in until Inst. D5.