XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag C
Shock Tower
Page 25
C5) Place the Ball Stud Lands (XF 3800) on the
shock tower, then install finger tight with the
5/8” flat head screws (XF 6024) If you use
thread lock, put a drop now in the lower
tapped holes of the ball stud lands to prepare
for inst. C6..
C6) Turn the bulkhead over and install the two
5/8” cap head screws (XF 6004) with flat
washers (XF 6080). Now tighten the flat
heads from C5.
C7) Check the Set-Up Sheet and Tuning Section. Install the two ball studs
you saved with any washers. We used the #2 hole with dialed Real Men
Wear Black 0.030” steel shims.