XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag B
Nose Pieces
Page 23
B10) Back to the top. Put the 13/32”
Stand-Offs (XF 6803) on the two
front screws (long arrows). They
should snuggle up with the top
stiffener (short arrow). If you are
using thread lock, put a drop in
the stand-off here. Hold them
with a pliers and tighten from the
bottom. Team drivers put a cloth
between the stand-off and the
pliers to keep the stand-off nice
and shiny. Secure the other four
screws with locking nuts (XF
6071).
B11) Place the complete front suspension
and steering on the X – 6 Cubed just
as it was on the B 4.2. Secure the top
plate (AE 9566) with the three screws
and countersunk washers that were on
the B 4.2. Drivers using thread lock
should put a drop in the stand-offs.
Finger tight for now. Make sure the
top plate is snug with the nose piece.
B12) Turn the car over and use the flat head
screws you saved to install the bulkhead
to the nose piece. When everything is
right, tighten the two bottom screws and
the three on top from B11,
B13) Use the saved flat head screws to put the
bumper on.
FRONT END’S DONE NOW, AND LOOKING GREAT!!!