XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag A
Transmission Assembly
Page 19
SLIPPER INSTALLATION
A24) Install a slipper plate (XF5530) onto the top
shaft, flat side out. The flats inside the plate will
key to the flats on the shaft.
A25) Put the inner slipper pad (AE9603) on the spur gear (AE9651) (left &
center photos). The hex of the pad fits into the molded hex in the gear.
Now turn the transmission so the top shaft with slipper plate is facing
down. Hold the plate on with your thumb and slide the spur gear, pad side
up, onto the shaft so the pad & gear are tight against the plate. Keep
pressure on the spur so the pad stays in its hex until step A27 below. This
is so much easier to do now than when the
transmission is in the car!
A26) Turn the transmission back over so the top shaft is pointing up, but be
certain the slipper pad remains engaged in the spur and the spur is tight
against the plate. Now place the slipper housing, with pads and center
plate, onto the top shaft, followed by the outer slipper plate.