XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed

Instruction Manual v1.0

Bag A

Transmission Assembly

Page 18

A21) Install the 4-40 X 3/8” cap head bolt (XF6001) in

the lower corner of the trans case, just finger

tight for now to hold things together.

A22) The X Factory 4-Gear motor plate (XF1234) has four “extra” holes. Two of

them (left photo, short arrows) are used to install the optional #5050

heatsink and fan. Two more may be used later if we make a gear cover

(center photo, short arrows). Long arrows in the right photo point to the

three holes that attach the motor plate to the transmission. Team drivers

put a drop of threadlock now in these three holes. Don’t put the

threadlock on the bolts as it will come off going through the transmission.

A23) Insert the three

4-40 X 1” screws from inst.16 through the three holes that go into the

motor plate and attach the motor plate (left photo arrows). The center rear

hole will not be used on the X – 6 Cubed due to a clearance issue. Use a

crossing pattern to tighten all four trans bolts to equal tightness. Check

one last time that the transmission rotates free and smooth. This is your

last chance!