XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag A
Transmission Assembly
Page 16
A16) Gather together the idler gear from the B 4.2 (AE9360) along with its 3/16”
X 3/8” bearings (XF6202) and shaft (XF5201) along with the same parts
from bag A so you have two gears, two shafts, and four bearings. Install a
bearing into each side of both idler gears. Team drivers do it by pushing
on the outer race with a socket.
A17) Slide an idler shaft through the bearings in each idler gear, then place the
shafts in their bosses in the left transmission half. Be certain all gears
mesh properly and the transmission turns smooth and free.
A18) Install the diff in the left
transmission case bearing,
ensuring it meshes properly with
the idler gear. The head of the
diff bolt should be up. Again, the