XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
Bag A
Transmission Assembly
Page 15
ASSEMBLE THE X – 6 Cubed TRANSMISSION
A13) Remove the transmission case
(XF5001) from Bag A and separate the
two halves. Note the small round ejector
pin bosses on the mounting tabs. You
may wish to file these flat for ease of
installation in the truck.
A14) Install a saved 3/16” X 3/8” rubber sealed
bearing (XF6200) all the way into the top
shaft boss in the left transmission case
half (short arrow) and a 3/8” X 5/8”
(XF6203) bearing from Bag A in the boss
for the differential (long arrow). The Team
pushes them in with the shank of an Allen
driver or, better yet, with a socket. See
Inst. A16.
A15) Make sure the spacer (AE9602) is on the top shaft (AE9601) and slide the
shaft with spacer through the bearing in the transmission case. If your top
shaft is worn, you will want to try our one-piece steel top shaft (XF5210)
made for us by M.I.P. No more spacer to lose and longer wearing too!