User Manual

Firmware upgrade
1. Turn off the X-CAM A10-3H
2. Uses the USB cable to connect with your PC, Normally the windows can find the driver
automatically, you will find the PORT number in the device manager.
3. Select the COM port number
4. Open the firmware file ( *.bin )
5. Click “Load and Connect” button
6. Turn on the X-CAM A10-3H, it will upgrade the firmware automatically
Notice: Please do not touch anything and keep the power on during the upgrade, if the
upgrade is break please back to STEP 1 and try again, normally it could be fix automatically. It
will beep 4 times after upgrade and the system will be restarted.
Announcements
1. Do not touch the gimbal during the initialization after turn on, Keep the gimbal in quietude
2. Do not use BEC for the gimbal power, use 2~4S Lipo battery
3. Strongly recommend using 12mm tube to mount the gimbal
4. Make sure the center of gravity of the gimbal is correct before using.
Disclaimer
X-CAMA10-3Hgimbalsarecoveredbyoneyearlimitedwarranty.Pleasedonotdisassembleormodifymechanicalstructure
inthewarrantyperiod.ThecustomizedprogramofX140BcontrolmoduleisbasedonA10-3Hstructureandmotors,andall
debugginghasbeencompletedinfactory.Anydirectorindirectdamagescausedbyauserduringuseordamagewillnotbe
coveredbyourwarranty,andX-CAMwillnotcompensatethelossandthecorrespondingliability.

X-CAMdoesnottakeanyresponsibilitytowardanydamageorlossinusingA10-3Hgimbal.