User Manual

ManualsBrandsX-Cam ManualsFPVA10-3H 3 Axis 360Deg Rotation GoPro Gimbal With A/V Link

X-CAMA10-3HforGOPRO3AxisGimbalUserManual



X-CAMA10-3HforGOPRO3AxisGimbalhasbeenfinishedwith

alltheadjustmentsbeforelaunchthemarket,READYTORUN.



Parameters

Weight:  280g(withoutGOPRO)

Stabilizationfrequency:  5200Hz

Inputvoltage(DC):  7.4v~16.8v(2S~4SLipo)



Tilttravel:  +-90degree;Rollingtravel:  +-45degree

YAW

travel:  360degreeswithunlimitedrotation

BuiltinAVouput&ChargingModule

AutoPilotSystemsupportingisnotrequired

Builtin3Gyroscopesensors&1Positionsensor

Supportsautomaticlocationfunction



Accessories



● 1xX-CAMA10-3HGimbalFrame

● 1xX-CAMA10-3HController

● 1xUSBCable

● 1xPPMCable

● 5xDampingballs

● 4xRubberrings

● 4xFastenerrings



Summary of content (5 pages)

PAGE 1
X-CAM A10-3H for GOPRO 3 Axis Gimbal User Manual X-CAM A10-3H for GOPRO 3 Axis Gimbal has been finished with all the adjustments before launch the market, READY TO RUN. Parameters Weight: 280g(withoutGOPRO) Stabilizationfrequency: 5200Hz Inputvoltage(DC): 7.4v~16.
PAGE 2
Connection Instructions TheS-BUSoutputcomeswithfullfunctionswhichhavebeendefinedchannelnumber: Channel1:ROLLControl Channel2:ReturntoHOME Channel3:TILTControl Channel4:YAWControl Channel5:Modeswitch Therecommendoperationmethods 1.
PAGE 3
PC Software Connect with PC Uses the USB adapter to connect with your PC , Normally the Windows can find the driver automatically, you could find the PORT number in the device Manager Launch the X-CAM Gimbal Stabilization Module Assistant , choose the correct port number and click CONNECT BEEP BEEP will be shouted after the connection succeed, the parameters will be read out automatically. The parameters as below: 1. Gains There are 2 gains, Position Gain and Acceleration Gain Pos.
PAGE 4
2. Gimbal Control The A10-3H provides 2 ways to control the TILT, Linear Mode: Linear Mode or Tracking Mode Push the TILT stick to high or low for moving the camera mount to up or down until the stick back to midpoint Tracking Mode: Push the TILT stick to high or low, the camera mount will follow the stick position. Push speed: 3. Setup the camera mount moving speed, high value set high speed; low value set low speed.
PAGE 5
Firmware upgrade 1. Turn off the X-CAM A10-3H 2. Uses the USB cable to connect with your PC, Normally the windows can find the driver automatically, you will find the PORT number in the device manager. 3. Select the COM port number 4. Open the firmware file ( *.bin ) 5. Click “Load and Connect” button 6.