User Guide

Play/Pause: double press right or left MFB to play. Double press again to play music
Next: Long press 2s-5s right MFB to go to next track.
Previous: Long press 2s-5s left MFB to go to previous track
Answer Call: one tap Right or Left MFB to answer incoming calls.
End call double press right or left MFB to end calls.
Reject call: When incoming a call, long press 1s, then reject the call.
ANC-Ambient-Off mode: Triple tab left or right MFB to change between different modes
X- light on/off: Double press AVS button
Activate Siri or Google: long press 1s AVS button.
Battery Capacity status: When connected to iOS devices, the
Iphone X and above version will not show the battery power in upper right corner due to limited top area on the
screen, and users have to pull down the screen to see the bettery power.
Charging: A new set of earphones has enough power for pairing and dialling out
several times. When it has low battery, please charge the charging case via USB cable for
2 hours and make sure the earbuds are placed correctly in the charging case. During charging, red LED flashes.
Once fully charged, blue LED
remains on.
Proximity sensor: Auto pauses when you take out only one, both still play. If you take out only one and put it into
the case, the other one can still play.
Waterproof
The KYGO Xellence are water resistant under classification IPX5. The earphones can tolerate water jets projected
by a nozzle (6.3mm) from any angle, rain and sweat.
Do not submerge them in water.
Bluetooth Pairing
Pairing with one phone or other devices:
1. Make sure the headphones are powered ON.
2. Press and hold the multifunction on left or right-side button for 5 seconds to enter into
pairing mode.
3. After red & blue LEDs flash alternately, there will be a sound to alert
you that they have entered into pairing mode.
4. Activate the Bluetooth function on your phone or device and search
for the headphones. Follow the instruction to enter “0000” as PIN if
the mobile phone reminder appears.
5. Earphones or device can now be used to play your phone music or
for phone calls.
Clearing pairing records and reset mode are the same operation. If reset mode means earbuds are dead,
then just place them into the case and reset.