Installation guide

Installing D Class Flash 5
Figure 4 Main board and Flash module
7. Remove the existing flash module. Locate the flash module and use the Phillips
Screwdriver to remove its retaining screw as shown in Figure 5. Lift the flash module
out of the socket.
Figure 5 Removing the existing flash module
8. Install the new flash module in the reverse order of removing the original flash module.
Carefully screw down its retaining screw until it is secure.
WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD. Before you
remove or install a module, touch any metal part of the chassis and keep that contact
with the chassis during the installation process.
9. Replace the speaker wire (plug in red wire) and the main-board shield (five screws).
10.Replace the cover in the reverse order as described in step 4 (align the cover screw
tabs with the screw holes and slide the cover toward the front of the thin client).
11. , Attach the cover screws in the reverse order as described in step 3.
12.Connect the power cord and power adapter, attach any other cables to the thin client,
and then attach the vertical foot.
CAUTION: Do not turn on the thin client. The thin client is ready to re-image, however
the flash module does not contain an operating system. Turning on power to your thin
client without firmware will display the error message “NO OPERATING SYSTEM
FOUND.”
What’s Next
Continue with "Installing Firmware."