Installation guide

4 Installing the 512 MB Flash Module
This chapter provides information on how to install the 512 MB Flash kit in a Wyse SX0L
thin client.
Removing the Existing Flash Module
To remove the existing Flash module:
Note
Refer to "Removing the Thin Client Cover" prior to installing the module.
1. With the thin client’s cover removed, carefully remove the existing Flash module from
the socket, noting where the connector of the module is located. Squeeze the plastic
standoff lock using Needle-nose pliers to allow module to be removed as the other
hand slowly rocks module out of the socket.
Figure 4-1 Removing the Existing Flash Module
Installing the New Flash Module
To install the new Flash module:
1. Install the new 512-MB Flash module into the location of the original module. Carefully
press module onto standoff lock and connector.
Warning
The flash module may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.