Specifications

34 Chapter 3
**Desktop=bitmap file
[Layout = {center, tile}]
The Desktop command specifies a bitmap file to be
used as wallpaper for the local desktop. This file could
be a 4-bit, 8-bit, or 24-bit BMP file or a standard GIF file
or a standard JPEG file. The file must be located in the
FTP server wnos\bitmap directory. Default is no
wallpaper.
Layout is a parameter of the Desktop command. It
specifies the arrangement on the desktop background of
the bitmap file specified by the Desktop command. For
the tile section, the image is replicated across the
desktop. Default = center. If auto dial-up is set, it will be
invalid.
Device=audio
volume={high, middle, low} or
{0-25}
mute={0, 1, 2}
Specifies the local audio volume.
high is the maximum volume, middle is medium volume
(default), and low is minimum volume. The values
between 0-25 allows you to set the exact volume level.
mute={0, 1, 2} sets the Mute check box in GUI (you can
also select the volume Mute check box by using the
GUI). If mute=2 is set it will disable audio and system
beep.
*Device=Ethernet
[Speed=speed]
[MTU=mtu]
Speed is either Auto, 10M HD, 10M FD, 100M HD or
100M FD. This parameter is the same as
EthernetSpeed. If it is set in wnos.ini, the statement in
the [username].ini will be disabled.
mtu is a value between 500 to 1500.
**Device=keyboard
[numlockoff={yes, no}]
[repeatrate={0-2}]
[repeatdelay={0-7}]
Specifies the local keyboard.
numlockoff=yes turns off the NumLock of the keyboard.
repeatrate={0-2} sets the repeat rate to Slow (0),
Medium (1) or Fast (2). Default = 1.
repeatdelay={0-7} sets the repeat delay to 1/5 second
(0), 1/4 second (1), 1/3 second (2), 1/2 second (3), 3/4
second (4), 1 second (5), 2 second (6), or No Repeat (7).
Default = 2.
This setting in wnos.ini will be saved into nvram if
EnableLocal is set to yes in wnos.ini.
Device=Wireless
[Mode={Infrastructure, AdHoc}]
[SSID=ssid Channel={1-14}]
[WepKey={None, 1-4}]
[Key1=k1]
[Key2=k2]
[Key3=k3]
[Key4=k4]
Defines wireless Ethernet device remotely. Not all
parameters are needed.
The values of k1 to k4 are any real value of 5 to 13
characters or 10 to 26 Hex digits. For example, you can
define Key1 to have a key of k1 and omit Key2, Key3,
and Key4, in which case WepKey must equal 1.
Table 3 wnos.ini and {username}.ini , Continued
Command/Parameter Description