Specifications

System Administration 23
Resetting to Factory Defaults Using G-Key Reset
High-privileged or Stand-alone users can reset the thin client to factory default settings
using the G-key reset.
To reset the thin client to factory default settings, restart the thin client and continuously
tap the G key during the restart process. G-key reset impacts all configuration items,
including but not limited to both network configuration and connections defined in local
NV-RAM.
Note
G-key reset is disabled for Low-privileged and Non-privileged users in
Lockdown mode.
Resetting to Factory Defaults Using Shutdown Reset
A High-privileged or Stand-alone user may reset the thin client from the Sign-off/Shutdown
dialog box as follows:
1. Select either the Shutdown and Restart the system or the Shutdown the system
option.
2. Select the Reset the system setting to factory defaults check box.
3. Click OK.
Shutdown reset impacts all configuration items, including but not limited to both network
configuration and connections defined in local NV-RAM (Terminal name will not change).
Shutdown reset is disabled if the current user is Non-privileged or Low-privileged,
regardless of lockdown state.
Resetting Display Settings Using V-Key Reset
If the display settings are inappropriate for the particular monitor that is connected, it is
possible that the display will not function properly when the thin client restarts. To correct
this, power-on the thin client while continuously tapping the V key. This will restart the thin
client with a display resolution of 640 x 480 pixels and a 60 Hz refresh rate.
Enabling a Disabled Network Setup Dialog Box
Although there are privileges and user modes associated with user access to thin client
resources (see "Understanding User Accounts and User Profile Ini Files"), access to
network setup (Network Setup dialog box) depends upon privilege level. A Stand-alone
user either is by default a user with High privilege or has a thin client that is locked down.
A Guest user has implicit privilege (of None) and all access is governed by that privilege.
A PNAgent/PNLite only user has whatever privilege was set in the wnos.ini file at boot,
whatever privilege was locked down at the last access of a wnos.ini file, or High privilege
(by default).
If the .ini file Privilege command is set to Low or None, the thin client Network Setup dialog
box will be disabled (the user cannot access it). There may be occasion to access the
Network Setup dialog box (without changing the .ini file) when this condition exists. This
situation could occur, for example, when you need to change to another FTP or Virtual