Installation guide

14 Chapter 5
Step 4 – Completing the Conversion Process
After loading the conversion image using WSI, the thin client should automatically reboot.
If DHCP auto-update options are defined, the thin client will check the RCA directory at
boot and auto-update (if required) to the code stored at this location. If DHCP auto-update
is not configured in your environment, manual updates can be performed through the thin
client user interface. For more information on managing XPe manually or through DHCP,
refer to the XPe documentation on the Wyse Web site.
Step 5 – Attaching the License Entitlement
The Wyse conversion kit is supplied with a Wyse license and a Microsoft COA label that
must be attached to each device as shown in the figure below (sufficient licenses must be
purchased for every device to be converted to a V90L).
Figure 5-3 Attaching the Wyse and COA labels
Caution
Failure to install the license and COA labels may cause delays in service and
support. This serial number must be given to the Customer Support
Technician to validate entitlement to support and service from Wyse. Failure
to do so will result in the original operating system being loaded on the
device and is in breach of your license agreement.