Installation guide

4 Installing the 512 MB Flash Module
This chapter provides information on how to install the 512 MB Flash kit in a Wyse VX0L
thin client.
Removing the existing Flash Module
To remove the existing Flash module:
Note
Refer to "Removing the Thin Client Cover" prior to installing the module.
1. With the thin client’s cover removed, carefully remove the existing Flash module from
the socket, noting where the connector of the module is located.
Figure 4-1 Removing the old Flash Module
Installing the new Flash Module
To install the new Flash module:
1. Install the 512 MB flash module into the location of the original module making sure to
align the plastic tab of the module’s connector with the notch in the connector on the
board.
Warning
The flash module may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.