Installation guide

3 Installing the 512 MB RAM Module
This chapter provides information on how to install the RAM module in a Wyse VX0L thin
client.
Removing the existing RAM Module
To remove the existing RAM module:
Note
Refer to "Removing the Thin Client Cover" prior to installing the module.
1. With the thin client’s cover removed, carefully remove the existing module from the
socket, noting where the connector of the module is located. Push the module locking
clamps, swinging them outward, from each side of the module to unlock it for removal.
2. Remove the module.
Figure 3-1 Removing the old RAM Module
Installing the new RAM Module
To install the new RAM module:
1. Install the 512 MB RAM module, label facing down, into the location of the original
module at the same angle.
2. Press module’s raised edge downward until it snaps in place.