Installation guide

4 Chapter 2
Required Tools and Materials
You will need the following tools to install the kit:
#1 Phillips screwdriver
Small Flat-Edge screwdriver
Warning
The RAM and Flash module may be susceptible to damage by Electro-Static
Discharge (ESD). All industry-standard cautions should be followed to avoid
ESD.
Removing the Thin Client Cover
To remove the cover of your thin client:
Caution
Follow all precautions listed in the Quick-Start Guide that came with your thin
client for disconnecting and reconnecting the thin client.
1. Perform a proper shutdown of the thin client by ending your session and clicking the
buttons as they appear; then press the power button to turn off the thin client.
2. Unplug the power cord, power adapter, remove all of the cables from the rear of the
unit, and detach the vertical foot.
3. Remove the two screws from the rear of the thin client using a #1 Phillips Screwdriver.
Figure 2-2 Removing the rear screws