Installation Manual

14 Chapter 4
Procedures
Complete the following procedures as an administrator (administrator privileges are
required).
Step 1: Copy the RX0L_LE 2G_4G WES2009 Conversion Image Folder to Your Local Hard
Drive
Navigate to the RX0L_LE 2G_4G WES2009 Conversion Image folder (contained on the
Conversion Software Assembly DVD-ROM) and copy it to your local hard drive.
Step 2: Install Wyse USB Firmware Tool 1.13
1. Navigate to the Wyse USB Firmware Tool v1.13_GA.exe (contained on the Conversion
Software Assembly DVD-ROM) and double-click it to execute the file and open the
WinZip Self-Extractor dialog box.
Figure 11 Extract files to your hard drive (C:\USBFT113)
2. Enter C:\USBFT113 in the Unzip to folder box, and then click Unzip to extract all files
from the Wyse USB Firmware Tool v1.13_GA.exe file into the C:\USBFT113 directory.
The default directory for the extracted files is Wyse USB Firmware Tool.
Caution
It is not recommended to use your desktop for the destination directory as
there are several files that will be extracted from the .exe file.
3. Create a shortcut on the desktop for the Wyse USB Firmware Tool.exe file (see your
operating system documentation).
Step 3: Use Wyse USB Firmware Tool to Configure a Single USB Key to Install Firmware
1. Double-click the shortcut on the desktop for the Wyse USB Firmware Tool.exe file to
run the tool and open the Wyse USB Firmware Tool wizard (the welcome page
provides the product version and description, and a link to view the Wyse end user
license agreement).
Caution
For Windows 7 Enterprise and Windows 7 Ultimate operating systems, be
sure to right-click on Wyse USB Firmware Tool.exe and select the Run as
administrator option).