Installation guide

Installing R90L Thin Client Flash and RAM 5
Step 2: Install the R90L Flash Module
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
1. Note where the connector of the flash module is located in Figure 4. Use needle-nose
pliers to squeeze the plastic standoff lock as you rock the flash module back and forth
to remove it from the socket.
Figure 4 Removing the existing flash module
2. Install the new flash module in the reverse order of removing the original flash module.
Carefully press the flash module onto the standoff lock and connector, making sure to
lock it into place.