Installation guide

Installing WES7 Firmware 11
Step 5: Verifying Thin Client Operation
After the thin client reboots, you can verify the Version and that your general client
information is correct.
Figure 13 Client Information (blank example)
1. On the General tab of the Client Information window (Start > All Programs > Wyse
Client Information), verify the following:
• Version is 9.01 Build 0806.
2. Click OK to close the Client Information window. The thin client is ready for operation
and setup by an administrator.
Tip
For security, automatic logon to a User desktop is enabled on the thin client
by default (and is a member of the User group; not a member of the
Administrator group). To log on as a different user or an administrator: Use
the Log off button (Start > Log off) to log off the current desktop while
holding down the SHIFT key until the Log On window displays. Log on as
follows (passwords are case sensitive):
Administrators - default Username is administrator and default Password is
Wyse#123.
Users - default Username is user and default Password is Wyse#123.
Administrator and other documentation for your thin client model are
available at: http://www.wyse.com/manuals
.