Instruction manual

15
Technical Support: [e-mail] US: [phone] EU: [phone]
ADVANCED OPERATION
1080i Stereo (using embedded EDID)
In instances where a connected display is
unable to achieve 1080p resolution (such
as using older or cheaper models), this DIP
setting will instruct the matrix to use embedded 1080i
video and stereo audio to output a signal.
After setting the DIP switch, reconnect and turn on for
EDID settings to take effect.
1080p 5.1 Audio (using embedded EDID)
When set to this DIP position the matrix will
use embedded 1080p video with 5.1ch
Audio. After setting the DIP switch,
reconnect and turn on for EDID settings to take effect.
1080p 7.1ch Audio (using embedded
EDID)
When set to this DIP position the matrix will
use embedded 1080p video with 7.1ch
Audio. After setting the DIP switch, reconnect and turn on
for EDID settings to take effect.
Remaining settings no function (reserved for future
update
AVR 7.1 Audio EDID COPY to Blu-ray source (AV
Receiver copy)
For users who wish to copy EDID from an AV Receiver
with 7.1 channel audio to a specific input port containing
a Blu-ray player, follow a variation on the instructions
above:
1. Set the DIP switch to the above position with the matrix
in the OFF position.
2. Connect the AVR to your desired OUTPUT port on the
matrix (for example, OUTPUT 2)
3. Power ON the matrix and select your INPUT on the
AVR, making sure your chosen SOURCE is connected
to (for example, INPUT 3 – Blu-ray)
4. Press and hold the OUTPUT SELECT button for 3
seconds for the EDID data to be copied from OUTPUT
2 (AVR) to INPUT 3 (Blu-ray).
1080p 3D Video / Stereo Audio
Setting the DIP switch to this position will
instruct the matrix to use embedded 1080p
3D video and Stereo audio to encourage
communication between the matrix and 3D sources/3D
displays if handshake problems are encountered.
After setting the DIP switch, reconnect and turn on for the
changes to take effect.
1080p Stereo using embedded EDID
(Default Factory Setting)
The matrix will use embedded 1080p
video and stereo audio in this DIP setting.
After setting the DIP switch, reconnect and turn on for
EDID settings to take effect.
RESETTING TO FACTORY DEFAULT:
As 1080p-3D-Stereo is the default factory setting for
the matrix, to reset EDID of all ports, simply set the DIP
switch to the above position when the matrix is
powered OFF. On powering ON, all ports will revert to
1080p-3D-Stereo and DIP switches can be adjusted
as necessary.