Instruction manual

10
Technical Support: [e-mail] US: [phone] EU: [phone]
1
BASIC OPERATION
The IR call-back function can be turned on and off as
required. See below
Setting: To enable IR call-back press and hold OUTPUT
2 and OUTPUT 4 together for 3 seconds until the LED
lights FLASH on OUTPUT 1 and OUTPUT 2. Call-back
is now activated and control of the Matrix is now possible
from remote locations.
To disable the call-back function, repeat the process until
the LED lights flash again.
Two-way IR Call-back Between Matrix, Sources and
Displays from Multiple Locations
A key feature on our HDBaseT Matrix range is discrete
IR control of the matrix, sources and displays from any
location – so inputs at the matrix end can be controlled
at a display location and displays can be controlled at the
matrix location.
This is accomplished by placing a series of IR emitters
on devices to control and IR receivers at all locations you
wish to control from to enable the IR signal to travel both
ways via the single Cat5e/6 cable.
At Matrix end: Insert the 3.5mm jacks of the IR TX
included with the unit into the IR TX ports at the rear of
the matrix according to input. The IR signal is added to
the HDMI of the input device so, for example, if the user is
watching Blu-ray on input 3, the IR signal will be directed
through the IR TX3 socket to control the device.
MX-0404-PP-KIT MX-0404-PP-KIT
Single Cat5e/6 70m/230ft
IR Receiver
Display Receiver
IR Path
HDMI
IR Path
Single Cat5e/6 70m/230ft
IR Receiver
IR RX Receiver
IR Emitter
IR TX
Display Receiver
IR PathIR PathIR Path
HDMI
HDMI