Installation guide

™
surintensité reste donc la même, la séquence
se répète.
For more information, refer to the Products or
Documentation pages at www.control4.com.
Requirements and Specifications
NOTES: (1) We recommend using Ethernet
with PoE (Power over Ethernet) rather than
WiFi for the best network connectivity. (2) The
Ethernet or WiFi network should be installed
prior to starting the HC-250 installation. (3)
The HC-250 is only compatible with PoE
injectors that have DC ground isolated from
AC ground. The easiest way to determine if
this is the case is to use PoE injectors that only
have a two-prong AC power cord.
The software required to configure this device is
Composer Pro. See the Composer Pro User Guide for
details.
HC-250 Specifications
Model Number
C4-HC250-BL
Network
Ethernet—required
WiFi (only supported
when the unit is used in a
single-Controller system or as a
Secondary Controller)
Media Recognition
Online CD/DVD/Blu-ray
recognition and media information
service
Video
HDMI 1.4 output; Component Video
output
Audio Playback Formats
MP3: 32kbps to 320kbps, CBR,
VBR, AAC, and FLAC
Display
LED indicators
HC-250 Controller
Installation Guide
Power Requirements
100-240 VAC, 60/50 Hz, 0.25 A
MAX. Power limits: 30W maximum,
10W minimum. PoE requirement:
13W. IR: <100 mW or 20mA of
current.
Contact (1)
DC - 36V maximum operation (low
voltage)
Maximum output current for 12V
rail: 125mA
Relay (1)
AC - 36V, 2A
DC - 24V
maximum operation (low voltage)
Dimensions (H x W x D)
1.23” (31.19 mm) x 8.59” (218.13 mm)
x 4.92” (125.01 mm)
Weight
1.3 lbs/0.589 kg
Shipping Weight
2.7 lbs/1.224 kg
Additional Resources
The following resources are available for more
support.
• Control4 Knowledgebase and Forums
• Control4 Technical Support
• Control4 website: http://www.control4.com
• Composer documentation in online help or PDF
format available on the Dealer portal
Front View
Figure 1. Front View
1 WiFi LED. This LED blinks first Red, then Orange,
and finally Blue during the boot process. When
the operating system is running, the WiFi driver
changes the LED color depending on the signal
strength of its connection to its associated
access point. Color/signal strength indicators:
Orange=Fair to Good, Blue=Excellent, and No
Light=No connection.
2 Data LED. The Blue LED indicates that the
Controller is streaming audio.
3 Link LED. The Blue LED indicates that the
2
1
2
3
4
5