Installation Guide

(figure 8)
(figure 9)
(figure 6)
(figure 7)
INSTALL BATHTUB
16. Apply a generous bead of adhesive or
silicone to the bottom of the tub supports
(figure 6).
17. Then apply a bead of tub and tile caulk
around the edge of the base (figure 6).
18.
Carefully set tub into position (gure 7)
and connect the drain hardware (previously
installed). Finish the installation of the tail
piece installation.
COMPL ETE BATHTUB
INSTAL L ATION
19. Fill the tub with water to the overflow and
then drain the tub while inspecting the
waste connections below the floor for leaks.
Access from below will be necessary for this
step (figure 8).
20. With the bathtub now in place, wipe o a
ny
excess tub and tile caulk and adhesive where
the tub meets the floor.
21. Run a bead of tub and tile caulk around the
bottom edge of the bathtub where it meets
the floor. Wipe o any excess caulk with a
wet cloth (figure 9).
CAULK
CAULK
SILICONE
SILICONE