Owners manual

Page 5
7.4 - Call Time Out Timer (d Digit).
------------------------------------
This option indicates the maximum of time that a call can be connected.
Programmable between 1 and 9 minutes (touch tone key 1..9). Programming a
value of 0 indicates Call Time Out timer has been turn OFF. In this case the
Dialink must rely on a CPC signal to hang-up. The factiry default value is 3
minutes.
7.5 - Pulse Dialing Rate (e digit).
-----------------------------------
The Dialink can pulse dial with 2 different speeds. Factory default is 10
pps.
Digit e Option
------------------------
1 ............... 10 pps
2 ............... 20 pps
7.6 - Silence Time Out (f Option).
----------------------------------
This option indicates how long a Call can be connected with no voice
activity. It can be programmed between 10 and 90 seconds (1..9 touch tone
keys). If the value 00 is programmed the timer is disabled. The factory
default value is 40 seconds.
;----------------------------------------------------------------------------
8 - Speaker options (configuration #34).
----------------------------------------
dial: a + b + c + d + e + f + # + 3 + 4
8.1 - Speaker Active during programming (a Option).
---------------------------------------------------
The speaker can be activated during programing mode. The factory default
value is activated. No yet implemented (to disable).
Digit a Option
------------------------
1 ............... active
2 ............... disable
8.2 - Speaker active during Dialing (b Option).
-----------------------------------------------
The Dialink can be set so, that during dialing the speaker is active. This
way you can hear the dialing tone, dialing, and call in progress. The
factory default value is active. Not yet implemented (to disable).
Digit b Option