Owners manual

Page 2
Timing/Dialing options (factory set 142314). 6 digits then #33
Speaker options (factory set 111111). 6 digits then #34
Announcer options (factory set 111111). 6 digits then #35
Diagnostic Requierment Code (factory set 111111) 6 digits then #40
Diagnostic options (factory set 000000). 6 digits then #41
;----------------------------------------------------------------------------
Central Station Receiver Number. 0-20 digitos #50
Central Station Voice Number. 0-20 digitos #51
;----------------------------------------------------------------------------
Note: 1 short beep indicates valid programming configuration. 4 Short beeps
indicated a non valid programming configuration and/or data.
3 - ID number (configuration #30):
----------------------------------
The ID number (up to 20 digits) is used by the emergency personnel to be able
to identify the location of the Dialink calling. It is sent when the
receiving party presses the "*" touch tone button. The emergency office can
see this number thru a touch tone monitoring device (Dialink- monitor). To
set the desired ID number, enter it in programming mode followed by the #30.
Example: Desired ID Code 234567, enter 2 3 4 5 6 7 # 3 0, you will then hear
a 1 beep confirmation beep from the Dialink.
;----------------------------------------------------------------------------
4 - Security Code (configuration #31):
--------------------------------------
This password is used to allow the emergency personnel or installer to
program the Dialink system. This password is used when the dip switch N.5 is
at the ON position, otherwise no password is needed and the system will enter
automatically the programming mode. The factory Default password is 123456.
The security code must be a 6 digit code, and cannot include # or *.
Exmaple: if the new password is 456789, enter 4 5 6 7 8 9 # 3 1
;----------------------------------------------------------------------------
5 - Voice announcer Options (configuration #32):
------------------------------------------------
The Dialink has a Voice announcer included as a standard (non-volatile
digital voice announcer up to 15 seconds). Which is used to identify the
location of the calling Dialink. The messages is recored directly from the
remote touch tone telephone (DTMF). The following options are available: