Owners manual

Page 12
19 - Telephone line specifications.
-----------------------------------
Line Type: Standard tw0-wire voice analog.
Line Voltage: 24 VDC minimum on-hook.
Loop Current: 30mA minimum.
20 - State Confirmation (beeps).
--------------------------------
19.1 - 1 Beep.
--------------
Is indicated when entering recording of the digital voice message, using the
touch tone keys * 7 during programming mode.
19.2 - 2 Beeps.
---------------
a. When receiving the keys * 8, to erase the digital voice message during
programming mode.
b. When the dip switch N.5. is OFF (no password needed), and the Dialink
answer the incoming call, indicating that it is in programming Mode.
c. When the Dialink is first turn on, during Factory testing and the serial
E2prom is not default programmed. The beeps indicate that the system has
made an auto default programming. Then on-hook.
d. Indicates that a valid configuration number and value have been accepted
(6 or 20 digits).
19.3 - 4 Beeps.
--------------
a. During the recording of the digital voice message, if the recording is
longer than 15 seconds and no touch tone has been pressed, inidcating an
error.
b. When the dip switch N.5 is OFF, and the serial E2prom is not installed or
is malfunctioning.
c. When recording a digital voice messages and it is less than 0.8 seconds
of duration. This messages will not be accepted.
d. During the programming of a configuration with up to 20 digits, if the 20
digits is exceeded it will be aborted and indicated with 4 beeps.
e. During programming if a non-valid configuration is addressed (#xx), the
system will indicate the fault. f. If trying to program configuration
#32 (voice announcer options), and the digital voice announcer message is
disable by configuration #35.
g. During the programming of the configurations #33 or #31, if less or more
than 6 digits are pressed.
h. If during the programming of the configurations #33 or #31, non numeric
values are used (* or #), the system will indicate the fault.
i. If during the programing to erase the digital voice messages is used (*
8) and the configuration #35 is set to disable the digital voice
announcer.