Owners manual

Page 10
13.1 - Emergency numbers.
-------------------------
The first number that is dialed during a emergency call this the one located
at the configuration #10. The next numbers will be dialed if programmed,
when a Busy or no answer call is detected. It will cycle between the numbers
programmed until a call is answered. To program the number enter the digit
plus the configuration desired (#10 .. #14).
To clear a dial number, enter 0 plus the option number (#10 .. #14).
To Program Press
* **
# *#
4 seconds pause *4
tone/pulse *5
0, 1, 2, ..9 0, 1, 2 ..9
13.2 - Info Numbers.
--------------------
The information numbers set at configurations #20, this the number or
extension dial when the information press button is activated (optional). If
no answer or busy is detected and the next information number has been set,
it will dial it. Cycling thru the available information numbers until a call
is answered. To set a information number, enter the desired number plus #20
.. #22. To clear a number simply program #20 .. #22 with no numbers
before.
-----------------------------------------------------------------------------
15 - Specifications:
--------------------
Requierments: The Dialink works directly form the telephone line, and
needs no external power supply.
Programming: From a touch tone telephone.
Dialing Mode: Tones (DTMF) or Pulses (10 pps or 20pps).
Digits Capacity: Up to 20 digits per dial number. Can included pause (4
seconds for access to central stations PABX, etc), *, #.
Conection: Paralell (tip y ring), with a RJ11 connector.
Circuit Protection: Diecor/Varistor lightning suppressor and full wave
polarity guard.
Auto Answer: Automatically activates on incoming ring signal (dip
N.7=on).
Visual LED: Called party presses *, or comunication connected.
Environment: -20 C a 60 C (-12 F to 135 F) with 5% to 95%
non-condensing humidity.