Owners manual

Page 9
12 - Normal Operation.
----------------------
When the emergency push button is pressed, the Dialink will active the line
and place a call to a pre-programmed telephone number. During the dialing
(pulse or tone) the connected call LED will flash. If during the dialing
process the number is Busy or does not answer the call, the dialink can be
set to dialing to a alternative number. The dialink will cycle between the
programmed emergency numbers (up to 5) until it connects a call. Once this
happens the digital voice announcer messages is given (so the remote party
knows the location of the emergency), the ID number is sent (if enabled), and
finally the connected call LED is turn on. Now a comunication is enabled
between the remote party and the location of the Dialink. After this if the
remote party presses again the touch tone key *, the digital voice
annoucement will be given again, then the ID. Once the key * has been
pressed, pressing the # key, will force the Dialink to hang-up.
13 - Central Station Operation.
-------------------------------
Once the Dialink has been activated with the emergency press button, it will
start to dial. If any voive configuration telephone has been programmed at
#10 .. #14, these numbers will be dialed first. After a pre-programmed
number of rings and no answer, or detecting a Busy signal, the Dialink will
hang-up and dial the Central Station telephone number set at configuration
#50. Once the Central Station answers, it will send a handshake tone to the
Dialink. Upon detecting the handshake tone, the Dialink will start
downloading the information set at configuration #30.
After sending this information (#30), is waits for a Kiss-Off tone from the
Central Station receiver. After this, the emergency Dialink telephone turns
on the Led of Call Connected and goes into the 2-way talk mode or hangs-up
and dials the telephone number set at the configuration #51 (if set).
Important: If your Central Station receiver does not support a talk-over
mode, a voice telephone number should be set at the configuration
#51.
If the Central Station answers the call and does not send a Kiss-Off, the
next number will be dialed (if set). In either single number or multi-number
programming, the phone will keep dialing until a call is completed.
14 - Telephone numbers.
-----------------------
Each telephone number can have up to 20 digits. The special function digits
as pause, dialing mode (tone/pulse), * key, or # key, are considered as 1
digit (even if to enter them, 2 touch tone keys are needed).