Owners manual

Page 7
10.1 - Central Station Options.
-------------------------------
a. Enter programming mode as described in section 1.
b. Enable/Disable central Station Mode
The Dialink can be configured to Central Station Mode, this is done by
programming a telephone number at the configuration #50. To cancel the
Central Station mode program #50 only with no telephone number.
c. Ring delay
During Central Station mode it is better to have the ring delay programmed
to a minimum of 4 rings. Most receivers send a long tone after answering
the line that could be detected as a ring back, therefore if the Dialink
is set to a ring delay of 3 or less, the telephone will on-hook
(disconnect).
d. Emergency Dial numbers
The Dialink can be set to dial only the Central Station, or first dial up
to one of the 5 Emergency dial numbers, and if no answer, then call the
Central Sation receiver. During the calling of one of the 5 emergency
dial numbers (configuration #10..#14), the Dialink will stay in 2-way
communication Mode. When calling the Central Station number
(configuration #50), the Dialink will be in a Listen only Mode, so it can
understand the hand shake signals of the receiver.
When the Central Sation receiver does not have a Talk over Mode, the
second Central Sation Number should be used (configuration #51). The
operation is the following, when the configuration #50 has a telephone
number, and the configuration #51 is cleared: the Dialink when dial first
the central station monitor receiver. After the receiver sends a
Kiss-Off, the Dialink lights the Call connected LED and goes into a 2-way
talk mode.
If dial numbers are programmed in both configurations (#50 and #51) the
operation will be the following one: the Dialink dials first the receiver,
and after the Kiss-Off signal, the Dialink will hang-up and dial the
telephone number at the configuration #51, for 2-way voice communication.
Important: If only a Central Station mode is to be used, the telephone of
the Central Station must be programmed at the configuration
#50, and the configurations #10 .. #14 must be cleared. The
LED of Call connected will turn on automatically, if a digital
voice announcer messages is recorded.
11 - Central Station Formats.
-----------------------------
The following text shows the different formats that are supported. This data
must be set at the configuration #30. Every example begins with a 4 digit
account number. This number is assigned by your Central Station for billing
and identification purposes. Remember that to set these configurations you
must be in programming mode (see section 1).