Specifications

Wuxi Weida Intelligent Electronics Co., Ltd. 无锡威达智能电子股份有限公司
13 / 18
2
、遥控器操作说明
Remote control instructions
1. 遥控器基本要求 Basic requirements for remote control
1).当连上蓝牙，遥控器发送蓝牙键值；未连接上蓝牙，则发送红外键值。
1). When Bluetooth is connected, the remote control sends the Bluetooth key value; when Bluetooth
is not connected, the infrared key value is sent.
2).指示灯：当连接 BT 工作时，按键闪烁蓝色灯；
未连接 BT，用 IR 工作时，按键闪烁红色灯。每按一次按键，指示灯闪一下。
2). Indicator light: When connected to BT, the button flashes blue light;
When BT is not connected, when working with IR, the button flashes red. Each
time you press the button, the indicator light flashes.
3). 低电压提醒：2.4V 以上蓝灯闪烁；
2.4V 以下红灯闪烁 5 次（任何状态下）
3). Low voltage reminder: The blue light flashes above 2.4V;
The red light below 2.4V flashes 5 times (in any state)
4).配对方法：
a.同时按住“OK”+“VOL-”键 3 秒，指示灯闪烁，配对成功指示灯常亮 3 秒后熄灭。
b.没配对成功时，如果还在按 OK+VOL-键就要一直发配对广播，以便用户可以配对。
c.按一次 OK+VOL-键就要能配对成功，不要反复清除配对再配对。一次按键配对成功后可以不再
发配对广播，直到下次重新按键。
d. Connection interval＜12ms
4). Pairing method:
a. Press and hold the "OK" + "VOL-" keys at the same time for 3 seconds, the indicator light
flashes, and the pairing success indicator light is always on for 3 seconds and then goes out.
b. When the pairing is not successful, if you still press the OK+VOL- key, you must keep
sending the pairing broadcast so that the user can pair.
c. Press the OK+VOL- button once to be able to pair successfully, do not clear the pairing
repeatedly and then pair. After a key pairing is successful, the pairing broadcast can no longer
be sent until the key is pressed again next time.
d. Connection interval＜12ms
5).遥控距离：≥10m
5). Remote control distance: ≥10m
6). 蓝牙设备名称：RemoteB016
6). Bluetooth device name: RemoteB016
7).支持 OK+Back 上报功能
7). Support OK+Back reporting function
8).支持连接蓝牙版本为 5.0 的设备
8). Support to connect to devices with Bluetooth version 5.0