User's Manual

◆ Remote Control
1
3
5
7
8
9
15
12
11
19
20
22
21
24
17
13
18
14
2
4
6
10
16
23
25
No. Items
1
2
3
4
5
6
7
8
9
10
11
12
13
ON/OFF
Mute switch
Netflix hotkey
YouTube hotkey
Prime Video hotkey
OPEN Browser hotkey
Red key
Green key
Yellow key
Blue key
Set
Signal Source
Left
Right
Up
Down
OK
Volume +/-
Projection mode
Focus +/-
Number
USB Source
BackspaceReturn
Home14
No.
15
16
17
18
19
20
21
22
23
24
25
Description Items Description
0~9
Note: The remote control of Bluetooth version can be paired as follows:
When the remote control is close to the projector within 0.2m, press [OK] and [Volume-]
simultaneously, and the indicator light flashes quickly to indicate the pairing state.
Enable the projector's Bluetooth function to search for the device, click Connect after
searching for [Smart Remote], and the indication “Connected” means successful
pairing. If it fails, repeat the above steps or restart the device for connection.
NOTICE：The terms HDMI and HDMI High-Definition Multimedia Interface, and the
HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the
United States and other countries.
This product contains technology subject to certain intellectual property rights of
Microsoft. Use or distribution of this technology outside of this product is prohibited
without the appropriate license(s) from Microsoft.
Content owners use Microsoft PlayReadyTM content access technology to protect their
intellectual property, including copyrighted content. This device uses PlayReady
technology to access PlayReadyprotected content and/or WMDRM-protected content.
If the device fails to properly enforce restrictions on content usage, content owners may
require Microsoft to revoke the device’s ability to consume PlayReady-protected
content. Revocation should not affect unprotected content or content protected by other
content access technologies. Content owners may require you to upgrade PlayReady to
access their content. If you decline an upgrade, you will not be able to access content
that requires the upgrade.
The camera on the device will collect projection screen information when performing
autofocus and auto keystone function, and the information will be released afterwards.
Such information shall not be saved or uploaded.
◆ FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio and the
double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
English: "
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device."
French:"
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectriquesubi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement."
L'appareil a été évalué pour répondre aux exigences générales d'exposition aux
RF. L'appareil peut être utilisé sans restriction dans des conditions d'exposition
portables.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.