Specifications

Wuxi Weida Intelligent Electronics Co.,Ltd. 无锡威达智能电子股份有限公司
15
下次开机时再次检测并升级。失败后，灯停止闪烁，遥控器退回老版
本正常运行；
When the TV is turned on and started, check the upgrade file of the
remote control. If there is an upgrade file, the remote control will be
upgraded, and the light will flash as a breathing light. At this time,
the remote control cannot be used, and any key has no response. After
the upgrade is successful, the light stops flashing. At this time, the
remote control can be used normally. If the upgrade fails, it will be
detected and upgraded again at the next boot. After failure, the light
stops flashing and the remote control returns to the old version for
normal operation;
6、 蓝牙设备名：RC-32。
Bluetooth device Name: RC-32.
7、 遥控器锁键功能：
Remote control key lock function
长按遥控器按键 60s，遥控器停止发码；抬起按键即恢复正常状态；
Long press the button on the remote control for 60s, the remote control
stops sending codes; raise the button and it will return to normal
status;
8、 回连功能：
Connect back function
在 4 米处遥控器与电视机保持连接至少 1 小时，不出现断连；在有配
对信息并且蓝牙连接断开的情况下，按下任意键发送对应的红外码，
并且发送回连广播 5 秒，回连成功指示灯闪 3 次。在有配对信息的情
况下，遥控器上电发送回连广播 5 秒，回连成功，指示灯闪 3 次。
Keep the remote control connected with the TV for at least 1 hour at 4
meters without disconnection; When there is pairing information and the
Bluetooth connection is disconnected, press any key to send the
corresponding infrared code, send the back connection broadcast for 5
seconds, and the back connection success indicator flashes for 3 times.
In the case of pairing information, the remote control will power on and
send the back connection broadcast for 5 seconds. The back connection is
successful, and the indicator light flashes for 3 time.
9、 Bug Report
红外模式下：按住“OK+Back”两个按键，同时发送 0x62；
蓝牙模式下：按住“OK+Back”两个按键，同时发送 0xEC（0x0C）