Specifications

Wuxi Weida Intelligent Electronics Co.,Ltd. 无锡威达智能电子股份有限公司
14
四、遥控器按键操作说明
Remote Control key action Description
1、 当连上机顶盒蓝牙，遥控器发蓝牙键值；未连上蓝牙模块，则发红外
键值。
When you connect the set-top box Bluetooth, the remote control blue
tooth key value, the Bluetooth module is not attached, the infrared key
value；
2、 红外状态下：按住按键持续发射码值，指示灯不闪烁，直到弹起或一
分钟后停止；
Under infrared status: press and hold the key to continuously transmit
the code value, and the indicator does not flash until it pops up or
stops after one minute.
3、 电池电量不足提醒：当电量低于 2.4V 时，指示灯闪烁 3 秒，频率
1HZ，指示灯颜色为红色；
Low Battery Reminder: When the power is less than 2.4V, The indicator
flashes for 3 seconds, the frequency is 1Hz and the color of the
indicator is red;
4、 配对功能：当同时按住“Back“和”Vol-“键并持续三秒，同时指示
灯闪烁，闪烁频率 2Hz，配对距离为 20cm 到 1.5m，如果配对成功，遥
控器红灯常亮 3 秒；如果 30 秒后配对失败，指示灯熄灭；
Pairing function: When the "Back" and " Vol- " keys are kept down for
three seconds,while the LEDs are blinking，Flashing frequency 2Hz；The
pairing distance is 20cm to 1.5m. If the pairing is successful, the red
light of the remote control will be on for 3 seconds; If pairing fails
after 30 seconds, the indicator light goes out.
Connection interval＜12ms；
遥控器距离>10m；
Remote control distance >10m;
5、 在电视机开机启动时，检测遥控器升级文件，若存在升级文件，遥控
器进行升级，灯呈呼吸灯闪烁。此时遥控器不可使用，任何按键无响
应，升级成功后，灯停止闪烁，此时遥控器可正常使用，若升级失败