Datasheet

User’s Manual
Page 8 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
If, while manually cycling the press, something obstructs the movement, stop
immediately and make sure that:
- the mini applicator is correctly mated to the press;
- the press is correctly set at the standard 135.8 mm shut height;
- the adjusting rings are not set too low (too small crimping height).
If the terminal is not correctly positioned, verify that:
- the feeding finger connects correctly with the terminal (strip holes);
- the brake lever is in the operating position.
Set the top adjusting ring according to the values on the identification plate and, using a wire of
the correct section, make some crimping tests. Should the obtained crimping height vary from the
data on the identification plate, please check the press set up