Datasheet

DETAIL OF CHANGE:
There will be three changes in the PCB layout.
Würth Elektronik will introduce a second PCB Layout (named “Debugging”) in addition to the existing PCB
Layout, which will be named “Permanent”.
Permanent Layout:
Würth Elektronik will improve the mechanical stability through moving the position of the non-plated through
holes. This allows the usage of the connector with vibrations up to 10g without any micro cuts x ≥ 1 µs.
Debugging layout:
The debugging layout has 0,1mm bigger drillings and a different position of the non-plated through holes.
Through lower mating forces, Würth Elektronik will increase the minimum mating cycles up to 50. This layout
can be used for programming or debugging, if the mechanical stability up to 10g is not needed.
Both Layouts:
The pad size has been slightly enlarged, to simplify the production of the PCB layout.