User's Manual

8.2.13 RpFlags: Configure the repeater flags of the module
Settings
index
Designation
Permissible
values
Default value Permissions
Number
of
Bytes
16
RpFlags
See
description
0 read/write
2
This parameter is used for the repeater configuration. See chapter 13 for more information
about the repeater mode.
Repeater and sniffer mode cannot be enabled at the same time.
The repeater function shall not be enabled in radio profiles 3 and 4.
The user is responsible for adhering to the statutory regulations for the fre-
quency and spectrum use when using the repeater mode with this module.
Especially the duty-cycle of each repeating network node must be checked
and controlled by the end system application in respect to CE compliance.
Bit no. Filter
Description
0 0x0001
Set this Bit to ’1’ to enable the repeater mode.
1 - 15 0xFFFE
Reserved for future use. All reserved Bits ’0’.
8.2.13.1 Example 1
Enable the repeater mode by setting the RpFlags parameter value to 0x0001 using the
CMD_SET_REQ . The 2 byte parameter is to be used LSB first.
Start signal Command Length Settings index Parameter CS
0x02 0x09 0x03 0x10 0x01 0x00 0x19
Response CMD_SET_CNF : Successfully modified the setting.
Themisto-I reference manual version 1.0 © August 2019
www.we-online.com/wireless-connectivity 56