User's Manual

7.6 Message overview
CMD Message name Short description Chapter
0x00 CMD_DATA_REQ Send data to configured address 7.2.1
0x01 CMD_DATAEX_REQ Send data to specific address 7.2.2
0x05 CMD_RESET_REQ Reset module 7.3.1
0x06 CMD_SET_CHANNEL_REQ Change the RF channel 7.4.2
0x07 CMD_SET_DESTNETID_REQ Set the destination network id 7.4.3
0x08 CMD_SET_DESTADDR_REQ Set the destination address 7.4.4
0x09 CMD_SET_REQ Change the UserSettings 7.5.1
0x0A CMD_GET_REQ Read the UserSettings 7.5.2
0x0D CMD_RSSI_REQ Request RSSI of last packet 7.3.6
0x0E CMD_SHUTDOWN_REQ Go to shut down mode 7.3.3
0x0F CMD_STANDBY_REQ Go to standby mode 7.3.4
0x11 CMD_SET_PAPOWER_REQ Change the radio TX power 7.4.1
0x12 CMD_FACTORY_RESET_REQ Perform a factory reset 7.5.3
0x40 CMD_DATA_CNF Data has been sent 7.2.1
0x45 CMD_RESET_CNF Reset request received 7.3.1
0x46 CMD_SET_CHANNEL_CNF Channel has been updated 7.4.2
0x47 CMD_SET_DESTNETID_CNF Destination network id has been updated 7.4.3
0x48 CMD_SET_DESTADDR_CNF Destination address has been updated 7.4.4
0x49 CMD_SET_CNF UserSettings have been updated 7.5.1
0x4A CMD_GET_CNF Return the requested UserSetting values 7.5.2
0x4D CMD_RSSI_CNF Return the requested RSSI value 7.3.6
0x4E CMD_SHUTDOWN_CNF Shut down request received 7.3.3
0x4F CMD_STANDBY_CNF Standby request received 7.3.4
0x51 CMD_SET_PAPOWER_CNF RF TX power has been updated 7.4.1
0x52 CMD_FACTORY_RESET_CNF Factory reset request received 7.5.3
0x80 CMD_REPEAT_IND Data has been repeater 7.2.4
0x81 CMD_DATAEX_IND Data has been received 7.2.3
0x85 CMD_RESET_IND Reset has been applied 7.3.2
0x8F CMD_STANDBY_IND Woke up from standby mode 7.3.5
Table 8: Message overview
Themisto-I reference manual version 1.0 © August 2019
www.we-online.com/wireless-connectivity 37