User's Manual

7.3 Requesting parameters, actions and events

This group includes all commands that will return read-only parameters or request actions

in the module.

7.3.1 CMD_RESET_REQ

This command triggers a software reset of the module. The reset is performed after the

acknowledgment is transmitted. All volatile settings are initialized with their defaults.

Format:

Start signal Command Length CS

0x02 0x05 0x00 0x07

Response (

CMD_RESET_CNF

Start signal Command | 0x40 Length Status CS

0x02 0x45 0x01 1 Byte 1 Byte

Status:

0x00: Request successfully received and processed

0x01: Request not successful

As soon as the module has restarted a

CMD_RESET_IND

is printed on the UART and the /RTS

line will show "module idle".

7.3.2 CMD_RESET_IND

This message indicates that the module has restarted. After the /RTS line is low and the

start-up time-out has passed, the module is ready to receive UART data and radio frames.

Start signal Command Length Mode CS

0x02 0x85 0x01 0x10 0x96

7.3.3 CMD_SHUTDOWN_REQ

This command triggers the shut down mode of the chip, which is the mode with lowest

power consumption. The shut down is performed after the command conﬁrmation message

is transmitted. The UART interface is disabled in shut down mode.

Format:

Start signal Command Length CS

0x02 0x0E 0x00 0x0C

Response (

CMD_SHUTDOWN_CNF