User's Manual

701-070801 Rev A This document contains proprietary information,
see proprietary statement on first page.
Page 78 of 85
keypad shall be touchable directly, or selectable via the cursor/value controls. An entry can be cleared
(restarted) by pressing the “C” button. Entry shall be completed by pressing the “Ok” button. The
Frequency-Entry dialog is depicted in Figure 93.
Enter Frequency
138.125
1 2 3
654
987
C
0
.
Ok
Figure 93 Frequency-Entry Dialog
6.4.3.4 Tone Entry
The Tone-Entry dialog shall allow the operator to input sub-audible tones. Both CTCSS (PL) and DCS
(DPL) tones shall be supported. Valid values for these tones are described in Appendix A. CTCSS tones
shall be displayed using their EIA code. DCS tones shall be displayed as a 3-digit number, padded with
a leading zero if required. Tones shall be selectable by touching them directly, or via the cursor/value
controls. A tone can be cleared (removed) by pressing the “None” tab. Entry shall be completed by
pressing the “Ok” button. The Tone-Entry dialog is depicted in Figure 94.
Select Tone
XA (71.9)
WA (74.4)
XZ (67.0)
CancelOK
DCSCTCSS None
Figure 94 Tone-Entry Dialog CTCSS